Flowmeters often fail in applications, including poor operation and flow disturbances and poor installation; there are air pockets in the air pockets and liquids; condensates in gases; wear and deposits, and so on. These errors often result in inaccurate or malfunctioning flow meter measurements. Poorly installed and improperly installed bad installations, common are: Although the inner diameter of the gasket is too small or the installation eccentricity has no or little effect on the flow values ​​of meters such as positive displacement, float, and Coriolis mass, additional pressure loss will be added. Dot peen marking works by electromechanically striking a carbide or diamond stylus assembly against the surface of a part to be marked.For example,Dog Tag Engraver.The result is a succession of dots to create digits, text, logos, and 2D data matrix codes. Each such dot is the result of a pulsed current that runs through a solenoid, punches a magnet toward the surface, and subsequently returns the stylus to its starting position, awaiting the next pulse. Because each pulse occurs in only a fraction of a second, an entire 2D data matrix code, for example, can be completed in seconds (depending on the size).
Compressed air is not required.
Dot Peen Marking Machine,Pnematic Dot Peen Marking Machine,Pneumatic Marking Machine,Dot Markers,Dot Peen Marker,Dog Tag Engraver Wuhan HAE Technology Co., Ltd. , http://www.chinahae.com
　
1) The acute angle of the standard orifice is not mounted on the inflow side.
2) The inner diameter dg of the seal gasket between the instrument and the pipe is smaller than the pipe inner diameter dp and the meter inner diameter dm to generate the beam current. Dg should be slightly larger than dm, such as dg
3) Seal spacer eccentric (not centered). The seal gasket is installed eccentrically, covering part of the flow area and making the velocity distribution seriously distorted and asymmetric. Since the asymmetrical flow occurs at the inlet of the flow sensor, that is, the length of the upstream straight pipe section is zero, measurement errors will be caused by differential pressure, turbine, vortex, ultrasonic, target, and electromagnetic instruments. For example, dn50mm magnetic flowmeter gasket eccentricity 10mm, measurement error as high as 4% to 10%.
4) The flow meter is in the wrong flow direction.
5) Install instruments that are sensitive to vibration disturbances on vibrating pipes.
6) Lack of necessary protective accessories.
Notable Characteristics:
Cost effective
Requires no consumables
High speed accuracy
Will mark any material (including hardened steel)
